Hardened steel pivot bushing for 130mm (5.12 inch) ID x 50mm (1.97 inch) L series excavator — boom, arm, and bucket joint replacement.

Case-hardened steel bushing manufactured to OEM dimensions for correct press-fit retention and long service life. 

Specifications:
- Material: Case-hardened steel (HRC 55–60)
- OD, ID, and length matched to OEM
- Surface: Phosphate-coated for installation

Joint locations covered:
- Boom foot pin
- Stick-to-bucket pivot
- Bucket cylinder rod end
- Arm-to-stick joint

Replacement notes:
- Inspect mating pin for wear before installing new bushing
- Use proper press tooling — do not hammer into place
- Grease before final assembly (where joint is grease-served)

Fits  130mm (5.12 inch) ID x 50mm (1.97 inch) L series

Stocked in Surrey, BC. Same-day dispatch on orders placed before 2 PM PST.

Need a specific OD/ID/length combination? Email info@powersoon.ca with your machine model and joint location.